Removing The Mp Card - HP Integrity rx2620 User's & Service Manual

Removing the MP Card

1. Record the network settings from your MP card before beginning this task.
2. Power off the server, disconnect all power and external cables and remove the
top metal cover.
3. Unscrew the two internal mounting screws that connect the MP card to the internal
chassis post.
Figure 60 Removing the MP Card
4. Unscrew the two external mounting screws that are located on both sides of the
25-pin serial connector as shown in
5. Disconnect the MP card connector.
6. Remove the MP card from the server by grasping it by its edges.
7. Install the MP blank (if not reinstalling the MP card) on the chassis. This blank is
used to fill the holes left by the 10/100 management LAN, 15-pin VGA and 25-pin
serial connectors. See
Figure 61.
Figure 61.
67