Figure 52 Removing the System Battery
Replacing the System Battery
1.
Lift up on the battery holder retaining clip with a flat-head screwdriver and slide
the battery into the holder. The positive (+) terminal of the battery faces up.
CAUTION:
stress on the battery holder retaining clip can damage the clip.
2.
Install the top metal cover. See
3.
Reconnect all of the power and external cables and power on the server.
4.
Verify the battery replacement by using the utilities identified in
(page
134). To verify operation, use the iLO MP commands.
5.
You might need to reset the server time and date using the EFI time and date
commands. After you set the time, power off the server, unplug the power cord,
and wait for one minute before powering on. Execute the time and date commands
again. If the time and date are correct, you have installed the battery correctly.
Only lift the battery high enough to clear the holder. Excessive
"Replacing the Top Metal Cover" (page
34).
Appendix C
59