2.
Perform all of the steps described in the procedure for
the MP Card" (page 66)
3.
Verify the battery replacement by using the utilities identified in
(page
134). To verify operation, use the iLO MP commands.
Removing and Replacing the LED Status Panel
The LED status panel card contains the server and diagnostic LEDs.
CAUTION:
replacing both the LED status panel and the system board, you must replace them
one at a time to avoid loss of server settings.
Removing the LED Status Panel
IMPORTANT:
the EFI prompt. After confirming that the first component has been replaced
successfully, shut off the server and replace the second component.
1.
Power off the server, disconnect all power cables, and remove the top metal
cover.
2.
Disconnect the LED status panel controller cable.
3.
Unscrew the two LED status panel mounting screws and remove the panel. See
Figure
63.
Figure 63 Removing the LED Status Panel
Replacing the LED Status Panel
1.
Replace the LED status panel in the server and install the two LED status panel
mounting screws.
2.
Connect the LED status panel controller cable.
3.
Replace the top metal cover and reconnect all power cables. Power on the server
and verify that the server and power LEDs illuminate.
Some server settings are saved to the LED status panel. If you are
First replace one component, then power on the server and boot to
"Removing and Replacing
Appendix C
70