Removing And Replacing Pci Card Cage; Removing The Pci Card Cage - HP Integrity rx2620 User's & Service Manual

Removing and Replacing PCI Card Cage

Accessory cards are installed in a removable PCI cage. This section explains how to
access the PCI card cage, and how to remove and install accessory cards.
WARNING!
disconnected from the server before removing or replacing a processor module.
Voltages are present at various locations within the server when an AC power source
is connected. This voltage is present even when the main power switch is in the off
position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION:
erratic server behavior or server failure.
Observe all ESD safety precautions before attempting this procedure. Failure to follow
ESD safety precautions might result in damage to the server.

Removing the PCI Card Cage

To remove the PCI cage from the server:
1. Power off the server and disconnect the power cable and all other cables from
the back of the server. See
2. Remove the top metal cover. See
(page 33).
3. Lift up on the PCI cage release lever and the back edge of the PCI cage and lift
the PCI cage out of the server.
Figure 53 Removing the PCI Cage
4. Grasp the PCI cage cover and slide it away from the bulkhead end of the cage,
then lift the cover off. See
Ensure that the server is powered off, and all power sources have been
Failure to properly complete the steps in this procedure will result in
"Powering Off the Server" (page
Figure
"Removing and Replacing the Top Metal Cover"
54.
27).
60