Replacing The Mp Card; Removing And Replacing The Mp Card Battery - HP Integrity rx2620 User's & Service Manual

Figure 61 Replacing the MP Blank
8. Push the MP blank against the inside of the chassis and Install the blank mounting
screw on the external connector side of the server chassis.
9. Replace the top metal cover and reconnect the power and external cables.

Replacing the MP Card

1. Record the network settings from your iLO MP before beginning this task.
2. Power off the server, disconnect all power and external cables, and remove the
top metal cover.
3. If you are installing a new MP card, remove the MP blank.
4. Unscrew the mounting screw for the MP blank, located on the external connector
side of the server chassis.
5. Remove the blank retaining tab from its socket on the server chassis and remove
the blank from the server.
6. Insert the MP card in the server.
7. Grasp its edges and place it on the two MP posts.
8. Push the 10/100 management LAN, 15-pin VGA and 25-pin serial connectors
through their openings on the back of the server
9. Connect the MP card:
a. Connect the MP card cable to its connector on the system board.
b. Install the two mounting screws that connect the MP card to the internal
chassis post.
c. Install the two external mounting screws that are located on both sides of
the 25-pin serial connector.
10. Replace the MP hardware connector.
11. Verify the MP card replacement by using the utilities identified in
(page 134). To verify operation, use the iLO MP commands.

Removing and Replacing the MP Card Battery

Systems with an MP card have two batteries. Systems without MP hardware have
only one battery. The main server battery is located on the system board. The MP
battery is located on the MP hardware.
Appendix C
68