Removing And Replacing A Removable Media Drive; Removing A Removable Media Drive - HP Integrity rx2620 User's & Service Manual

Figure 58 Replacing the PCI Backplane
3. Replace any accessory and graphics cards.
4. Connect server power, PCI, and LAN cables.
5. Power on the server. See
6. Verify the installation of the PCI backplane:
Look at the LEDs of all PCI cards for proper operation.
Run mapper from the Offline Diagnostics CD to ensure that all PCI cards
are identified.
Monitor the SEL to ensure there are no events showing peripheral problems.

Removing and Replacing a Removable Media Drive

The removable media drive is located behind the front bezel.
WARNING!
disconnected from the server before removing or replacing a removable media drive.
Voltages are present at various locations within the server when an AC power source
is connected. This voltage is present even when the main power switch is in the off
position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION:
Failure to follow ESD safety precautions could result in damage to the server. Failure
to properly complete the steps in this procedure will result in erratic server behavior
or server failure.

Removing a Removable Media Drive

To remove a removable media drive:
1. Power off the server and disconnect all cables. See
(page 27).
"Powering On the Server" (page
Ensure that the server is off, and all power sources have been
Observe all ESD safety precautions before attempting this procedure.
28).
"Powering Off the Server"
65