Removing And Replacing Pci Card Cage - HP Integrity rx2620 User's & Service Manual

Replacing the System Battery
Step 1. Lift up on the battery holder retaining clip with a flat-head screwdriver and slide the battery into
the holder. The positive (+) terminal of the battery faces up.
CAUTION
Step 2. Install the top metal cover. See "Replacing the Top Metal Cover" on page 51.
Step 3. Reconnect all of the power and external cables and turn on the server.
Step 4. Verify the battery replacement by using the utilities identified in Appendix C, "Utilities," on
page 167.
• Use the iLO MP commands to verify operation.
Step 5. You may need to reset the server time and date using the EFI time and date commands. Once you
have set the time, turn the server off, unplug the power cord, and wait for one minute before
turning it back on. Execute the time and date commands again. If the time and date are now
correct, you have installed the battery correctly.

Removing and Replacing PCI Card Cage

Accessory cards are installed in a removable PCI cage. This section explains how to access the PCI card cage,
as well as how to remove and install accessory cards.
Ensure that the server is powered-down and all power sources have been
WARNING
disconnected from the server prior to removing or replacing a processor module.
Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning could result in personal injury or damage to
equipment
Failure to properly complete the steps in this procedure will result in erratic server behavior or
CAUTION
server failure. For assistance with this procedure contact your local HP Authorized Service
Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Removing the PCI Card Cage
To remove the PCI cage from the server, perform the following steps:
Step 1. Turn off the server and disconnect the power cable and all other cables from the back of the server.
See "Powering Off the Server" on page 42 for more information.
Step 2. Remove the top metal cover. See "Removing and Replacing the Top Metal Cover" on page 50.
Chapter 4
Only lift the battery high enough to clear the holder. Excessive stress on the battery
holder retaining clip may damage the clip.
Removing and Replacing Components
Removing and Replacing Internal Components
79