Connections - Gigaset N510 IP PRO Manual

Managing base connections – activating/deactivating

connections

You can manage your base connections using the Web page:
¢
Settings Telephony
This Web page displays a list with all possible connections and your status (e.g., con-
nected, registered):
IP Connections
You can assign up to six VoIP connections (VoIP phone numbers) to your phone. You need
to set up a VoIP account with a VoIP provider for each VoIP phone number. You must save
the access data for each account and for the relevant VoIP provider in the phone.
A list entry is available for each VoIP connection; this is used to configure and manage the
connection.
¤
To do this, click the corresponding [Edit] button.
Configuring/deleting VoIP connections
To configure and delete VoIP connections, open the Web page
¢
Settings Telephony
¤
Click the [Edit] button next to the list entry for the VoIP connection.
This opens a Web page which you can use to set up a new account or to change the data
of an existing one.
¤
To set up a new VoIP account in the VoIP Configuration / Profile Download area, click
[Start Configuration Assistant] and then go through the steps of the configuration
£
assistant, page
In the other areas you can change the data of an existing account.
u
Personal Provider Data
u
General data of your service provider
u
Network data for your service provider
If in the configuration assistant you have selected a provider for which there is no profile
available, you must enter all data for the VoIP account here. Your VoIP provider will give
you this data.
– If you cannot hear the caller on an outgoing call, you may have to switch between
outbound proxy server mode and STUN use. In the sent data packets, the STUN or
outbound server replaces the private IP address of your phone with its public IP
address. If you operate your phone behind a router with symmetric NAT, STUN can-
not be used.
– If you are sometimes unavailable for incoming calls, you may have to adjust the
value in NAT refresh time:
If you have not activated port forwarding or set up a DMZ on the router for the
phone, an entry in the routing table for the NAT (in the router) is required to make
the phone available. The phone must confirm this entry in the routing table at cer-
tain intervals (NAT refresh time) so that the entry stays in the routing table.
For detailed information on the areas, see the online Help for this Web page. Open the
online Help by clicking the question mark
Configuring the phone via the Web configurator
¢
Connections
¢
Connections
96.
(at the top right of the Web page).
99