Connecting The Base - Gigaset N510 IP PRO Manual

First steps

Connecting the base

The following diagram is an overview of all connections for your base. The individual con-
nections are described in detail below. In order to make calls over VoIP, you must connect
the base to the Internet (see diagram below) and register at least one handset to the base
£
( page 15).
Follow the steps in the order given below:
§§1§§
Connect the power cable to the base.
§§2§§
Connect the base to the mains power supply.
§§3§§
Connect the base to the router/switch to access the Internet and configure the base
via the Web configurator.
(Internet connection via router and modem or via router with integrated modem)
§§4§§
Connect the PC to the router.
Please note
Your Gigaset N510 IP PRO is supplied with sufficient power via PoE (Power over Ether-
net) if the device is connected to an Ethernet switch with PoE functionality
(PoE class IEEE802.3af ). In this case, it is not necessary to connect the device to the
mains power supply and steps
10
3
2
§§1§§
and
4
§§2§§
should be omitted.
1