Updating The Phone Firmware - Gigaset N510 IP PRO Manual

Configuring the system settings
Assigning receive connection(s)
Prerequisite: Several connections are configured for your phone.
¢
Ï Settings
v
A list of internal parties (handsets) is displayed.
q
Select the internal parties that should be assigned new receive connections
and press the display key
A list containing all configured connections is opened. You can select Yes or No for each
connection.
r
Select Yes if you want the relevant connection to be the receive connection
for the internal party. Select No if it should not be the receive connection.
s
Change to the next connection.
¤
Repeat these two steps for each connection.
¤
Press the display key
Please note
u
If a new connection is configured, it is assigned as the receive connection to all
internal parties and Answer Machine 1.
u
If a connection is not assigned as the receive connection to any internal party, calls
on this connection will not be signalled.

Updating the phone firmware

Prerequisite: The phone is connected to the Internet (i.e., connected to a router,
£
page 12).
If necessary, you can update your phone's firmware.
The firmware update is downloaded directly from the Internet by default. The relevant
Web page is preconfigured in your phone.
Prerequisite:
The phone is in idle status i.e.,
u
No calls are being made.
u
There is no internal connection between the registered handsets.
u
The base menu is not open in any of the handsets.
Starting the firmware update manually
¢
Ï Settings
v
Update Firmware
Select and press
~
Enter the system PIN and press
The phone establishes a connection to the Internet.
§Yes§
Press the display key to start the firmware update.
82
¢ ¢
Telephony Rec. Connections
§OK§
§Save§
to save the changes.
¢
System
§OK§
.
.
§OK§
.