Table of Contents
Advertisement
Configuring the system settings
Updating the phone
firmware
Prerequisite: The base is connected to the
Internet (i.e., connected to a router,
¢
page
16).
If necessary, you can update your base's
firmware.
The firmware update is downloaded directly
from the Internet by default. The relevant
Web page is preconfigured on your base.
Prerequisite:
The base is in idle status i.e.,
u
No calls are being made.
u
There is no internal connection to/
between the registered handsets.
u
No handset has the base menu open.
Starting the firmware update
manually
¢
¢
Ï Settings
v
Update Firmware
Select and press
~
Enter the system PIN and
§OK§
press
The base establishes a connection to the
Internet.
§Yes§
Press the display key to start the
firmware update.
Please note
u
The firmware update can take up to
three minutes.
u
When updating from the Internet,
checks are made to ensure that no
newer version of the firmware exists.
If this is not the case, the operation is
terminated and a message is issued to
that effect.
122
System
§OK§
.
.
Updating firmware automatically
Your base will check daily whether a newer
firmware version is available from the Inter-
net on the configuration server. If firmware
updates are available, the message New
firmware available. Update? is displayed in
the idle display of the base.
§Yes§
Press the display key to confirm
the prompt.
The firmware is loaded onto your base.
If you answer the prompt with
returns to idle status. Your base will no
longer remind you that firmware updates
are available. The message will only be
shown again if a newer version of the
firmware is available to download. You can
also carry out the firmware update manually
¢
(
page
122).
Please note
If the base is not connected to the Inter-
net at the time when the check for new
firmware is to be carried out (e.g.,
because the router is deactivated), the
check is carried out as soon as the base is
reconnected to the Internet.
You can deactivate the automatic version
check via the Web configurator.
Activating/deactivating the
DECT interface
If you deactivate the DECT interface, the
radio connection between the base and the
registered handsets is terminated. Handsets
are "asynchronous" to the base. They cannot
establish a connection with the base and no
calls are signalled. Handsets do remain regis-
tered to the base and will synchronise with
the base as soon as you reactivate the DECT
interface.
¢
Ï Settings
¢
v
¢
DECT Interface
§No§
, the base
System
Advertisement
Table of Contents
