Table of Contents
Advertisement
GL-1020 Administrator's Guide
5
In the Device Name field, enter the controller name.
6
Enter the controller's Workgroup.
7
Enter the address of the Primary WINS Server.
8
Enter a WINS Scope ID for the controller.
9
To set the controller as a master browser, click the
drop-down list and select
Browser
10 Click
.
Save
Configuring AppleTalk Settings
1
On the Administration tab, click the
2
Click the
Wireless Network
The Wireless Network page opens.
3
In the AppleTalk area, click the
4
Select
to enable AppleTalk.
Enable
5
Enter the AppleTalk Zone string.
.
6
Click
Save
Configuring the Wireless NIC Settings
1
On the Administration tab, click the
2
Click the
Wireless Network
The Wireless Network page opens.
3
In the General area, enter the controller's SSID.
4
Select the Network Type from the drop-down list.
5
If required, check
The WEP Encryption, WEP Key and Authentication fields
are enabled.
6
Select the type of WEP Encryption from the drop-down list
box.
7
Enter the WEP Key as 5 or 13 sets of hex characters.
8
Select the Authentication mode from the drop-down list box.
9
Enter the identifier of the Default Access Point as 6 sets of
hex characters (Infrastructure network type only).
10 Enter the Channel number (Ad Hoc network type only).
Enable
Setup
link.
Protocol
Setup
link.
and
Use WEP Security
Master
.
subtab.
drop-down list.
subtab.
.
Set WEP key
103
Advertisement
Table of Contents
Troubleshooting
