— Configuring Discovery Settings
You can configure the discovery settings.
Devices
Click the arrow button to display the poll-down list and check the model name that you want
to search.
Network - Enable IPX/SPX Search
This is disabled because the Remote Scan driver does not support the IPX/SPX connection.
Network - Enable TCP/IP Search
Select this to search for devices connected to the TCP/IP network. This is available only
when the TCP/IP protocol is installed.
When this is enabled, select how it searches devices in the TCP/IP network.
- Search local subnet — Select this to search devices in local subnet.
- Specify a range — Select this to search devices in specific range of IP addresses.
When this is selected, enter the IP addresses in "From" field and "To" field to specify the
range.
- IPv4 — Select this to search for devices set with an IPv4 address.
- IPv6 — Select this to search for devices set with an IPv6 address.
Scanning Remotely Using Remote Scan Driver
139