Cannot See Gl-1020 Device - Toshiba GL-1020 Administrator's Manual

CANNOT SEE GL-1020 DEVICE

Possible Cause
Controller is
initializing and is not
online yet
Controller is down
256
Problem Description
After installing and configuring the GL-1020 controller, you
cannot see it on the network. This could be the result of controller
problems, but is more likely to be caused by network
configuration errors.
The following checklist helps you identify the source of the error
and directs to you where you can find more information about
resolving it. If the problem persists after you have followed all of
the steps, contact TOSHIBA's authorized dealer for further
assistance.
Troubleshooting Checklist
Cannot Find GL-1020
Check
1 Did a startup page print out? If
not, wait until the controller
comes online. Examine the
protocol settings that print out
on the startup page. Are they
correct?
2 Are any error messages, such
as "Starting Controller. Please
wait." displayed on the copier's
control panel LCD?
For
Instructions,
Yes No Go To...
→
Modifying
Next
Step
Protocol Settings
↓
using the Control
Panel
page 42.
→
"Starting
Next
Step
Controller, Please
↓
Wait" or "Shut-
down in Progress,
Please Wait"
Message Appears
on page 239.
GL-1020 Administrator's Guide
on