Configuring Appletalk Protocol Settings - Toshiba GL-1020 Administrator's Manual

48

Configuring AppleTalk Protocol Settings

1 From the Network Setting menu, press
the AppleTalk Setting screen.
Sample AppleTalk Setting screen on copier control panel
Note: Currently, the controller supports EtherTalk access
only; TokenTalk is not supported.
2 By default, Macintosh printing is enabled. If it has been
disabled, press
ENABLE
3 Press
APPLETALK NAME
4 Enter the AppleTalk name. The name is the same as the
Microsoft Computer Name (device name).
By default, the device name is GL<MAC Address>, where
MAC Address is the media access control number of the NIC
installed in the controller. For example,
You can specify a different name of up to 15 alphanumeric
characters, provided it is unique within your network.
5 Press
DESIRED ZONE
6 Enter the AppleTalk Zone, which is "*" by default. This
indicates the local zone, although you can specify a different
name of up to 15 alphanumeric characters.
7 Press to save your changes.
OK
APPLETALK
to establish Macintosh print services.
to display the touch keyboard.
GL00DOC9165206
to display the touch keyboard.
GL-1020 Administrator's Guide
to display
.