Rear side removals
Rear door and cover removal
1
Open the rear door.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
2
Remove the two screws (A).
3
Remove the rear door and cover.
Fuser removal
1
Remove the rear cover. See
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
2
Remove the right cover. See
3
Disconnect the cable JEXIT1.
"Rear door and cover removal" on page
"Right cover removal" on page
Parts removal
234
4600-830, -835, -895
A
234.
186.