Kohler Enclosed Cvt Addendum; Drive System Service: Safety And Tips - Cub Cadet 6X4 Shop Handbook

DRIVE SYSTEM SERVICE: SAFETY AND TIPS

1. When working on the vehicle, set the parking
brake or block the wheels to keep it from rolling.
2. Place the transmission in neutral.
3. When working on any parts (like the CVT) that
rotate with the engine, disable the engine:
3a. Disconnect and ground the spark plug
wires on a gasoline engine.
3b. Remove the key from the key switch.
3c. Disconnect the ground cable from the neg-
ative terminal of the battery.
4. Unless a procedure specifically requires the
engine to be running, it should be turned-off for
all maintenance, adjustments, and repair.
5. There are some simple but specialized tools
needed to loosen the belt, remove the driving
pulley, and align the engine to the transfer case.
• A small screw can be used to spread the
sheaves of the driven element so that the belt
can be removed. Dimensions are in the text.
• A clutch puller (part number: 759-04111) is
needed to pull the driving element off of the
tapered crankshaft.
• Use the alignment tool (part number: 707-
04878) to check spacing and alignment between
the crankshaft and the transfer case input shaft.

KOHLER ENCLOSED CVT ADDENDUM

63
Kohler Enclosed CVT Addendum
6. Standard tools that will be useful include:
Item
Combination wrench
Ratchet + sockets
Torque wrench
Drill motor and bit
Center-punch
Tor-X driver
Alignment tool
6mm-1.0 screw
Clutch puller
Rivet gun
Sizes
1/2", 9/16", 30mm
5/16", 1/2", 9/16",
5/8", 10mm,
22mm
9/32"
T-20, T-27
P/N: 707-04878
2.9cm thread lgth.
P/N: 759-04111