Cub Cadet 6X4 Shop Handbook page 212

Chapter 7 - Kohler Engine Service Access and Fuel System
8. There are three fittings on top of the fuel tank:
See Figure 7.37.
Fuel pick-up
Fuel tank
Figure 7.37
8a. The fuel level sending unit, mounted fur-
thest forward
8b. The fuel tank vent, with no line connected
to it (plastic fitting)
8c. The fuel pick-up for the engine (brass fit-
ting)
9. Raise the cargo box and tilt-up the passenger
seat to reach the fuel tank.
10. To remove the fuel tank: See Figure 7.38.
Fuel line:
disconnected and clamped
Figure 7.38
• Disconnect the fuel line from the fitting on top of
the tank. Clamp the line to prevent spillage or
contamination.
• Unplug the electrical connection to the fuel level
sender
Fuel level
sender
Fuel tank vent
11. Remove the two screws that fasten the fuel tank
hold-down wire to the frame. See Figure 7.39.
Hold-down wire
Screws
12. Lift the fuel tank hold-down wire up, and pivot
the front of the tank inward. See Figure 7.40.
Pivot tank
then pull back
to remove it
13. Pull the fuel tank back and out to remove it.
13.1. When installing the fuel tank reverse the instruc-
tions for fuel tank removal.
208
Figure 7.39
Figure 7.40