Cub Cadet 6X4 Shop Handbook page 45

7c. Remove the four screws that hold the
adaptor housing to the transfer case using
a 1/2" wrench. See Figure 2.88.
Figure 2.88
7d. Lift the adaptor housing off of the transfer
case, noting the tension pin that indexes
the two housings to each-other.
7e. Pry or cut the hog ring off of the input
shaft. Discard the hog ring and replace it
with a new one when the transfer case is
being assembled. See Figure 2.89.
Input shaft
Hob ring
Figure 2.89
Chapter 2- Drive System: CVT and Transfer Case
Adaptor
housing
Tension
pin
7f. Remove the screws that hold the case
halves together using a 1/2" wrench.
7g. Gently separate the case halves using the
three pry points, and a soft hammer if nec-
essary. Do not pry against the mating sur-
faces to separate the case halves.
See Figure 2.90.
Right case
half (down)
NOTE: The portion of the case that was lifted-off
is identified as the "Left Case Half". The other is
the "Right Case Half".
8. Input shaft:
NOTE: If new pinion gears, and the middle shaft
gears that mate with them are installed in the
transfer case, orientation of the gears on the
shaft is unimportant. Once a wear pattern is
established on the gear teeth, orient the gears to
maintain that wear pattern. See Figure 2.91.
Pinon gear
NOTE: wear pattern
41
Lift left case half
Figure 2.90
Middle shaft gear
Figure 2.91