Cub Cadet 6X4 Shop Handbook page 44

Chapter 2- Drive System: CVT and Transfer Case
5d. Check the plastic split-busings for wear.
They are inexpensive, and replacing them
if there is any significant wear will
improve shift action. See Figure 2.84.
Plastic split
bushing
Figure 2.84
6. Remove the safety switches and detents:
6a. Unscrew and remove the two neutral
safety switches using a 7/8" wrench.
See Figure 2.85.
Neutral
safety
switches
Figure 2.85
Bolt
Nut
plastic
split bushing
spacer tube
6b. Remove the detent plate using a 3/8"
wrench. See Figure 2.86.
Detent
springs
6c. Remove the detent springs.
6d. Clear any sealant flash from the detent
bores, and remove the detent balls using
a magnet, if necessary.
7. Separate the case halves:
7a. Remove the two sets of nuts and bolts that
hold the case halves together through un-
tapped holes. Use a pair of 1/2"
wrenches.
7b. Support the transfer case by the housing,
with the screws that secure the case
halves together facing up.
See Figure 2.87.
40
Detent plate
Figure 2.86
Figure 2.87