Safety Switches - Cub Cadet 6X4 Shop Handbook

Table of Contents

Advertisement

Chapter 9 - Electrical
Key Position
STOP
Run w/ Lights
Run
Start
Spade
Wire (gas)
G
Green
B
Red / White trace
A2
Red / White trace
A1
White (2x)
S
Orange / White
M
Red / Black trace
L
Yellow (2X)
Spade
Wire (diesel)
G
N/A
B
Red / Black trace
A2
Red / Black trace
A1
White
S
Orange / Black
M
N/A
L
Yellow (2X)
The terminals are connected to the wires identi-
fied in the above tables.
Terminal
Continuity
M - G - A1
B - A1
L - A2
B - A1
B - S - A1
Function
Constant
ground
Fused hot,
jumper to A2
Fused hot,
jumper to B
Energize run
systems
Initiates power
to starter circuit
trace
Engine stop
Headlights
Function
Fused hot,
jumper to A2
Fused hot,
jumper to B
Energize run
systems
Initiates power
to starter circuit
trace
Headlights
9.

Safety Switches

9a.
The transmission switches are located in
a separate sub harness that consists of a
simple loop connecting the two switches
in series.
The orange and grey wires of the transmission
harness can be found just outboard of the front
edge of the transfer case. See Figure 9.9.
Switch (harness unplugged)
Both switches
in series:
contacts closed
There are two sets of shift forks within the trans-
fer case. Each shift fork has a safety switch
associated with it.
When both shift forks are in the neutral position,
the contacts of both switches will be closed.
The switches are connected in series, so the clo-
sure of both switches completes the circuit.
9b. To test the transmission safety switches:
Confirm that the transaxle is in neutral by rotat-
ing the transfer case input shaft and observing
the reaction of the output shafts.
Locate and disconnect the harness that leads to
the neutral safety switches.
Connect a DVOM or continuity light to the pair of
terminals on the disconnected harness.
When the transfer case is in neutral, there
should be continuity (0.0 Ω) between the two
wires in the terminal.
If there is no continuity through the circuit
when the transfer case is in neutral, check the
switches individually to identify the one with con-
tacts that are open.
280
Figure 9.9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poly bed 4x2Steel-bed 4x24x4

Table of Contents