Cub Cadet 6X4 Shop Handbook page 57

3i. Install the 22-tooth forward (high) gear and
spacer onto the input shaft.
See Figure 2.126.
Spacer
22-tooth
forward gear
Figure 2.126
3j. Insert the shorter, thicker end of the output
shaft through the third bearing in the right
side case half. See Figure 2.127.
Output shaft
Figure 2.127
3k. Install the bull gear on the output shaft. If
the bull gear or pinion gear have not been
replaced, reinstall the gear in its original
orientation. Refer to the marks made on
removal.
Chapter 2- Drive System: CVT and Transfer Case
Input shaft
53
3l. Install the spacer on the output shaft.
See Figure 2.128.
Figure 2.128
3m. Install the final pinion on the middle shaft.
The shoulder on the gear should face the
forward (high range) gear. The flat side
faces up.
3n. Install the snap ring that secures the final
pinion. Use a new snap ring.
See Figure 2.129.
Final pinion
(flat-side up)
Figure 2.129
3o. Apply a small amount of anti-seize com-
pound to the inside diameter of the low-
range shift collar.
3p. Position the shift collar on the low-range
shift shaft assembly.
3q. Apply a small amount of grease such as
Cub Cadet multi-purpose grease (P/N
737-3034) to the low range shift shaft.