Testing Switches; Diodes - Cub Cadet 6X4 Shop Handbook

Table of Contents

Advertisement

Chapter 9 - Electrical
11.

Testing switches:

Refer to the "COMPONENTS" section of this
chapter that describes the function of the individ-
ual switches to be tested.
Switches can be tested "hot" by looking for volt-
age at the appropriate posts.
This is not definitive, since the source of the volt-
age is not always confirmed.
Checking for voltage does not work on switches
that work by providing a ground path to the mag-
neto primary windings or a solid state control
device.
The most valid way to test switches is a conti-
nuity test.
11a.
Understand the internal functions of the
switch. Key switches and PTO switches
can be fairly complex.
11b.
Isolate the switch from the rest of the cir-
cuit.
11c.
Test each pair of terminals for continuity in
all modes of switch operation: at-rest, and
actuated.
11d.
Many switches on Cub Cadet equipment
are typed by their at-rest state: Normally
Open, Normally Closed, Common.
Normally Open (N.O.) contacts do not complete
a circuit when the switch is at-rest (plunger
extended). They close to complete a path
through the switch when the plunger is
depressed.
Normally Closed (N.C.) contacts complete a cir-
cuit when the switch is at-rest (plunger
extended). They open to break the path through
the switch when the plunger is depressed.
Some Cub cadet switches contain more than
one pair of contacts. The same switch housing
can contain normally open and normally closed
switch elements.
When testing a switch that contains more than
one set of contacts (elements), the male spade
terminals associated with Normally Closed con-
tacts will be stamped "N.C."
The male spade terminals that are associated
with each-other face each-other broad-surface
to broad surface. See Figure 9.75.
Normally Closed
switch element:
Spades marked: "NC"
12.

Diodes

What is a diode?: A diode acts like a one way
valve, allowing current to flow in only one direc-
tion. See Figure 9.76.
Silver band
(-)
electrons flow from the negative to the positive.
312
Normally Open
switch element:
Spades blank
Figure 9.75
(+)
Figure 9.76

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poly bed 4x2Steel-bed 4x24x4

Table of Contents