Removing Cylinder Head - Skoda OCTAVIA Workshop Manual

15
------------ 15-4 ------------
Cylinder Head, Valve Gear
Remove cylinder head
Note:
All cable straps that have been loosened or cut
open when removed must be fitted again in the
same location when installed.
Special tools, testers and aids required
♦ Workshop crane (e.g. V.A.G 1202 A)
♦ Catch pan (e.g. V.A.G 1306)
♦ Pliers for spring strap clips
♦ Lifting device MP 9-201
♦ Wrench for injection lines (e.g. 3035)
Work procedure
Note:
If the battery is disconnected and reconnected,
carry out certain additional operations ⇒ Elec-
trical System; Repair Group 27.
- Disconnect the earth strap from the battery
with the ignition off.
K - Remove engine cover ⇒ page 10-2.
K - Remove noise insulation in the middle as well
as on left -arrows-.
- Remove the air guide pipe between the
charge air cooler and the intake manifold.
- Unscrew the oil return-flow line from the tur-
bocharger at the cylinder block.
- Unscrew the oil feed line from the turbo-
charger.
- Unscrew bracket for oil feed line to turbo-
charger from intake manifold.
- Remove exhaust pipe from turbocharger.
- Remove the V-ribbed belt ⇒ page 13-1.
- Drain coolant ⇒ page 19-3.
OCTAV1A
Edition 04.04
S00.5110.57.20