Disassembling And Assembling Oil Filter Holder - Skoda OCTAVIA Workshop Manual

17

Disassembling and assembling oil filter holder

1 - Screw plug, 25 Nm
2 - Gasket
♦ replace
3 - Oil cooler
♦ ensure clearance to surrounding com-
ponents
♦ pay attention to Note ⇒ page 17-1
4 - Gasket
♦ replace
♦ fit into the grooves on the oil cooler
5 - Seal
♦ up to 03.01
♦ cut open and replace if leaking
------------ 17-2 ------------
Lubrication system
6 - Screw plug, 10 Nm
♦ up to 03.01
7 - Screw plug
♦ up to 03.01
♦ must not be opened
8 - Spring
♦ up to 03.01
♦ for pressure relief valve 0.5 MPa
(5 bar)
9 - Piston
♦ up to 03.01
♦ for pressure relief valve 0.5 MPa
(5 bar)
10 - 0.09 MPa (0.9 bar) Oil pressure switch
F1, 25 Nm
♦ grey
♦ inspecting ⇒ page 17-5
11 - Gasket
♦ replace
12 - 15 Nm + torque a further
♦ replace
13 - Oil filter holder
14 - Seal
♦ replace
15 - Oil feed line
♦ to turbocharger
16 - Banjo bolt, 20 Nm
17 - Cap, 25 Nm
♦ slacken and tighten with oil filter wrench
3417
18 - O-ring
♦ replace
19 - Oil filter element
♦ pull off from cap -item. 17-
♦ when changing oil filter replace
O-rings -item. 18-.
OCTAVIA
/ turn (90°)
1
4
Edition 11.02
S00.5110.56.20