Installing Cylinder Head - Skoda OCTAVIA Workshop Manual

15
------------ 15-6 ------------
Cylinder Head, Valve Gear
K - Hang the lifting device MP 9-201 at the cyl-
inder head.
Note:
Attach the induction pipe with a wire to the car-
rier lug of the lifting device in order to achieve a
stable centre of gravity for the cylinder head.
- Slightly raise the cylinder head with the work-
shop crane.
- Swivel the cylinder head to the left out of the
rear toothed belt guard and simultaneously
remove the tensioning pulley.

Installing cylinder head

Notes:
♦ Always replace cylinder head bolts.
♦ Carefully remove residual sealant from the
cylinder head and cylinder block using a
chemical cleaner. Make sure this does not
cause any extended scoring or scratching.
♦ Carefully remove all abrasive residue.
♦ Remove the new cylinder head seal from its
wrapping immediately before fitting.
♦ Treat the new gasket with the utmost care.
Damage to the silicone layer and in the area
of the bead results in leakages.
♦ There must be no oil or coolant in the blind
holes of the cylinder head bolts in the cylin-
der block.
Special tools, testers and aids required
♦ Workshop crane (e.g. V.A.G 1202 A)
♦ Torque wrench
♦ Pliers for spring strap clips
♦ Guide bolts MP 1-208
♦ Adjusting straightedge MP 1-312
♦ Lifting device MP 9-201
♦ Wrench for injection lines (e.g. 3035)
♦ Wire
♦ Wrench for cylinder head bolts (e.g. 3452)
OCTAV1A
Edition 04.04
S00.5110.57.20