Skoda OCTAVIA Workshop Manual page 99

OCTAV1A
Edition 04.04
S00.5110.57.20
Cooling System
- Install toothed belt ⇒ page 13-4.
- Install the V-ribbed belt ⇒ page 13-1.
- Fill coolant ⇒ page 19-3.
Removing and installing coolant
regulator
Special tools, testers and aids required
♦ Torque wrench
♦ Pliers for spring strap clips
Removing
- Drain coolant ⇒ page 19-3.
K - Remove coolant hose from connection fit-
ting -2-.
- Unscrew screws -1- and remove connection
fitting -2- together with O-ring -3- and cool-
ant regulator -4-.
- Turn the coolant regulator 90° (
the left and detach from connection fitting.
Installing
- Clean sealing surface for O-ring.
- Replace O-ring and moisten with coolant.
- Insert coolant pump into the connection fit-
ting and turn 90° (
specting: The clamp of the coolant thermo-
stat must be positioned vertically.
- Tighten screws -1- to 15 Nm.
- Filling system with coolant ⇒ page 19-3.
Test coolant regulator
- Heat thermostat in water bath.
Opening start
approx. 87 °C
cannot be tested
1)
/ turn) to
1
4
/ turn) to the right. In-
1
4
Opening start Opening stroke
approx. 102 °C at least 7 mm
1)
------------ 19-7 ------------
19