Skoda OCTAVIA Workshop Manual page 73

OCTAVIA
Edition 08.96
S00.5110.50.20
Cylinder Head, Valve Gear
Removing
- Remove camshaft ⇒ page 15-16.
- Remove bucket tappets (do not mix up) and
place down with running surface facing down.
- Move piston of the relevant cylinder into top
dead centre (TDC).
K - Insert assembly device MP 1-213 and set
mounting at height of stud bolt.
- Use assembly lever and thrust piece MP
1-211 to remove valve springs.
Note:
The valves are supported on the piston crown
when carrying out this step.
K - Use MP 1-206 to pull off valve stem seals.
Installing
K - Fit plastic sleeve -A- onto the valve stem in
order to avoid damaging the new valve stem
seals.
- Oil valve stem seal -B-, insert into the fitting
tool MP 1-306 and carefully push onto the
valve guide.
Notes:
♦ Wait about 30 minutes before starting the
engine after installing the camshaft. The
hydraulic compensating elements have to
settle (otherwise valves will strike the piston).
15
------------ 15-15 ------------