Skoda OCTAVIA Workshop Manual page 20

10
------------ 10-12 ------------
¡ ¡ ¢ £ ¤ ¥ ¦ §
Removing and Installing Engine
The engine should be attached with the engine
holder MP 1-202 to the repair stand for carrying
out removal and installation operations.
Note:
The engine must not be attached to the repair
stand for measuring the cylinder bore ⇒ page
13-23.
K - Attach suspension device MP 9-201 to the
plates at the engine and take up weight of
engine with a workshop crane, e.g. V.A.G
1202 A:
♦ Belt pulley side:
♦ Flywheel side:
Warning!
Use locking pins at the hooks and at the rig pins
to prevent them slipping out.
- Attach engine to repair stand with engine
              ! " # $ % #  &  # ' (  )
holder MP 1-202.
Installing
Notes:
♦ Always install new seals and gaskets when
carrying out removal and installation work.
♦ Always install new self-locking nuts.
Installation is carried out in the reverse order;
pay attention to the following points:
- Check whether dowel sleeves for centering
engine/gearbox are inserted in the cylinder
block.
K - Attach intermediate plate to sealing flange
and push onto the dowel sleeves -arrows-.
- Check centering of the clutch driven plate.
- Check clutch release bearing for wear, re-
place if necessary.
- Apply a thin film of grease G 000 100 to the
splines of the input shaft.
¨ ©  ¢ ¥ ¨
engine to
2nd hole in rail - item 1
2nd hole in rail - item 7
OCTAVIA
stand
Edition 05.01
S00.5110.55.20