Skoda OCTAVIA Workshop Manual page 63

OCTAV1A
Edition 04.04
S00.5110.57.20
Cylinder Head, Valve Gear
Work procedure
- Before fitting the cylinder head position the
crankshaft on TDC marking of cylinder 1
⇒ page 13-7. The adjusting straightedge MP
1-312 must allow itself to be used in the cam-
shaft.
- Fit on the cylinder head gasket.
- To centre it, screw in the guide bolts MP 1-
208 into the outer holes on the suction side.
K - Hang the lifting device MP 9-201 at the cyl-
inder head.
Note:
Attach the induction pipe with a wire to the car-
rier lug of the lifting device in order to achieve a
stable centre of gravity for the cylinder head.
- Swivel cylinder head into rear toothed belt
guard.
- While swivelling the cylinder head into the
rear toothed belt guard, simultaneously
push the tensioning pulley.
- When inserting the cylinder head, pay at-
tention to the position of the rear lugs on
the cylinder head gasket. When insert-
ing they must not be buckled up by the
heat shield of the exhaust manifold.
- Insert 8 new cylinder head bolts and tighten
manually.
- Remove the guide bolts by screwing out with
a bolt tightener from MP 1-208 and screw in
the cylinder head bolts by hand.
K - Tighten cylinder head bolts in the order shown:
- 1st pre-tighten with the torque wrench to:
Stage I = 40 Nm
Stage II = 60 Nm
15
------------ 15-7 ------------