Skoda OCTAVIA Workshop Manual page 30

13
------------ 13-6 ------------
Crank Assembly
K Fig. 1 Installation position of the semi-
automatic tensioning pulley
The holding claw -arrow- must engage in the
recess on the rear toothed belt guard.
Removing toothed belt
Engine installed in the vehicle
- Remove right headlights ⇒ Electrical Sys-
tem; Repair Group 94, Removing and install-
ing headlights.
- Remove engine cover ⇒ page 10-2.
- Remove plug from the intake manifold pres-
sure sender (G71) and intake manifold tem-
perature sender (G72).
- Remove the air guide pipe between the
charge air cooler and the intake manifold.
- Unbolt coolant expansion reservoir and place
to the side.
- Unbolt power steering reservoir and place
to the side.
- Unbolt washer fluid reservoir and place to
the side.
- Unbolt fuel filter and place to the side.
- Remove the noise insulation.
- Remove the air guide pipe between the char-
ge air cooler and the exhaust turbocharger
⇒ page 21-9.
For all vehicles
- Remove top toothed belt guard and cylinder
head cover.
- Remove vacuum pump for brake servo unit
⇒ page 15-3.
- Remove the V-ribbed belt ⇒ page 13-1.
OCTAV1A
Edition 04.04
S00.5110.57.20