Connecting Components
7
Select "SAVE & EXIT SETUP" and press Enter.
8
Press Y, then Enter.
The settings are saved and the server restarts.
Adding a SCSI hard disk drive
Specific technical knowledge is required to install or replace a hard disk drive (HDD). If
you are not sure how to proceed, Toshiba recommends that you ask your authorized
service provider to install or replace HDDs.
CAUTION: Take care when handling hard disk drives. Avoid subjecting the hard
disk drive to shock or vibration. The disk could be damaged and its data destroyed.
SCSI configuration
When installing SCSI HDDs, start at the bottom of the 3.5-inch device bay and work up to
the top of the 5.25-inch device bay.
SCSI HDD installation order
Jumper settings for SCSI HDDs
To connect a hard disk drive to the SCSI chain, you must set the jumper for each drive
according to its position in the chain.
Jumper block locations and settings
SCSI HDD 3 (SCSI-ID = 3)
SCSI HDD 2 (SCSI-ID = 2)
SCSI HDD 1 (SCSI-ID = 1)
SCSI HDD 0 (SCSI-ID = 0)
Adding a SCSI hard disk drive
51