Replacing The Head Open Sensor - SATO CL4NX Service Manual

5.11 Replacing the Head Open Sensor

Required tool:
• Phillips screwdriver (JIS #2 or equivalent)
1
Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2
Remove the left housing cover.
Refer to Section 5.1.1 Remove the Left Housing
3
Remove the gearbox.
Refer to Section 5.10 Replacing the Timing
4
Remove the screw ., remove the
3
cable and replace the sensor
$
PCB .
5
Perform the assembly with the reverse
procedure.
After the replacement
• Check the head open error message.
Refer to Section 4.7 Checking the Head Open
Cover.
Belt.
Error.
5 Replacement
3
2
CL4NX/CL6NX Service Manual
1
87