SATO CL4NX Service Manual page 119

16
Attach the front cover
17
Attach the dispenser bracket

dispenser unit

screws to attach the unit.
Note
Before attaching the dispenser unit, make sure that
the NIP springs are in the correct position.
If the NIP spring is in the wrong position, push the
NIP spring in the arrow direction using a long nose
pliers.
1
to the printer.

to the
. Tighten four
6 Installation of Options
5
34
Correct position
The end of the spring is positioned on the bearing.
Wrong position
The end of the spring is positioned on the groove.
CL4NX/CL6NX Service Manual
32
33
117