8
Perform the assembly with the reverse procedure.
After the replacement
•
Check the media sensor.
Refer to
Section 4.3 Checking and Adjusting the Media
•
Adjust the print darkness.
Refer to
Section 4.5 Adjusting the Print
•
Adjust the pitch.
Refer to Adjusting the Print Position in chapter 5 of CL4NX/CL6NX operator manual.
•
Adjust the offset.
Refer to Adjusting the Media Stop Position in chapter 5 of CL4NX/CL6NX operator
manual.
Note
The different versions of the main (CONT) PCB are as shown below.
The main (CONT) PCB with the revision code,
CL4NX-CONT-REV1.0, is used in the CL4NX
printer.
Revision code
Sensor.
Darkness.
The main (CONT) PCB with the revision code,
CLNX-CONT-REV1.0 or later, is commonly used
in both CL4NX printer and CL6NX printer.
Revision code
CL4NX/CL6NX Service Manual
5 Replacement
79