SATO CL4NX Service Manual page 123

5
Cut three joints using a nipper to remove
the portion in the circle of the media
0
holder plate .
Make sure that there is no burr remains on the cut
surface.
6
Attach the gearbox
• First, route the motor cable
motor.
• Attach the gearbox
• Then, tie the motor cable
shaded area.
• Lastly, insert the motor cable
#
of the liner rewinder and tighten four screws
12 13
&
around the motor as shown. Do not overlap on the shaded area of the
# %
using four screws . Make sure that the motor cable is not pinched.
&
using a cable tie
&
into the slot at the bottom of the printer center frame.
Joint
14
15
'
as shown. Do not overlap the motor cable
CL4NX/CL6NX Service Manual
6 Installation of Options
11
%
.
14
&
on the
121