Print position adjustment
1
After you load the media and ribbon, close the print head and top cover. Then power
on the printer.
2
Adjust the pitch in the Factory menu. (refer to Tools > Test Print > Factory in Chapter
4 Operation and Configuration of the CL4NX/CL6NX operator manual)
3
Perform a factory test print to check the print position.
Standard
10 to 11 mm
4
If the print position is in the case of A, reduce the pitch. If the print position is in the case
of B, then increase the pitch.
5
After adjusting the pitch, perform a factory test print again.
6
Check the cutting position. If necessary, perform steps 2 through 5 until the cutting
position is correct.
Media feed direction
6 Installation of Options
A
B
CL4NX/CL6NX Service Manual
137