22
Attach the left housing cover
tighten the screw
Checking and Adjustment after the Installation
Preparation:
• Load direct thermal media to the printer for checking the print position. (Linerless media is not
required)
• Check that the firmware version is 1.3.0.r7 or later. (Refer to Information > Build Version in Chapter
4 Operation and Configuration of the CL4NX/CL6NX operator manual)
Error message checking
1
After you load the media and ribbon, close the print head and top cover. Then power
on the printer.
2
Pull the tab to open the cutter-open
lever.
0
and
"
.
6 Installation of Options
Place down
& Slide
10
11
Open
Cutter-open lever
CL4NX/CL6NX Service Manual
135