7.3 Replacing the Print Head
You can easily remove and replace a damaged or worn print head.
WARNING
• Do not touch the power button, connect or disconnect the power cord while your hands are wet. Doing so
could cause an electric shock.
• Disconnect the power cord from the AC outlet before you replace the print head.
• Wear gloves before replacing the print head, to prevent damage to the print head.
1
Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2
Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
3
Push the head lock lever q towards the
rear to unlock the print head.
CAUTION
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
4
Remove the media and ribbon if they are
already loaded.
Refer to
Section 3.3 Removing the Ribbon
the reverse procedure in
Media.
and
Section 3.5 Loading
7 Appendix
CL4NX/CL6NX Operator Manual
1
297