SATO CL4NX Service Manual page 79

5
Tilt the sensor guide lock
pull out the media sensor guide $.
6
Remove the screw
4
tension . Replace the defective sensor holder assembly with a new sensor holder
1
assembly .
7
Insert the new sensor holder assembly
the printer center frame. Push the sensor holder assembly
4
sensor tension
8
Perform the assembly with the reverse procedure.
After the replacement
• Adjust the media sensor.
Refer to Section 4.3 Checking and Adjusting the Media
3
down and
/
attaching the sensor holder assembly
/
using the screw .
2
5
1
by aligning the rail to fit in the protrusion of
1
Sensor.
CL4NX/CL6NX Service Manual
5 Replacement
3
1
and sensor
4
6
all the way in. Attach the
77