SATO CL4NX Service Manual page 18

2 Operation and Configuration
Verify
Tools > Service > RFID > Verify
Enable or disable the verification of data written on tag.
The options are as follows:
• Enabled: Perform the verification by reading the data of the written tag.
If not match, the printer prints VERIFY TAG ERR on the label.
• Disabled: Do not perform the verification of the written tag.
PREND Type 3/4
Tools > Service > RFID > PREND Type 3/4
Set the output content of the external signal PREND (Print Done).
Reflect the timing of write (stop media feed) of RFID tag to the TYPE3 and
TYPE4 waveforms of PREND (Print Done) signal.
The options are as follows:
• Normal: Use the usual PREND signal.
• Motion: Reflect the timing of write (stop media feed) of tag to the
PREND signal.
For the waveforms during the settings of Normal and Motion, refer to the
timing chart as follow.
16
CL4NX/CL6NX Service Manual