SATO CL4NX Service Manual page 59

Pressure balance setting
The adjustment procedure for the pressure balance is as follows:
1
Open the top cover of the printer.
2
Find the adjustment dials . on the top of the print head assembly as shown.
3
Turn the adjustment dials . according to the media width and set the pressure
balance.
For CL4NX:
Media Width (mm)
Pressure Balance Gradation
*First use the gradation setting for the head pressure and then adjust according to the media width.
Above table shows an example when the head pressure is Left
For CL6NX:
Media Width (mm)
Pressure Balance Gradation
*First use the gradation setting for the head pressure and then adjust according to the media width.
Note
• The factory default setting is Left
For CL6NX dispenser model, the factory default setting is Left
• If the media is shifted to the right after adjusting the dial, turn the head pressure balance adjustment screw
to counterclockwise. (If media is shifted left, turn to clockwise.) Refer to
Pressure Balance with Adjustment Screw
25 - 54
p
Left
n
Right
50 - 120 120 - 140
r
Left Left
n
Right
Right
p p
and Right .
for details.
4 Checking and Performing Printer Adjustments
54 - 83
p
Left
o
Right
p
.
140 - 160
p q p
or Left or
n o
Right
q q
and Right .
Section 4.9.1 Adjusting the Head
CL4NX/CL6NX Service Manual
83 - 131
p
Left
p
Right
160 - 180
q p q
Left or
p q
Right or
57