Table of Contents
Advertisement
Chapter
3
Overview
Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel Centronics interface instead of the IEEE
1284 interface.
1. Load the configuration to be changed (for example, Config. 1).
a. Press the
b. Press the ↓ key until the following message displays:
c. Press the
d. When the desired number displays, press the ↵ key to select it. The
2. Move through the menu and change all the desired values. (In this
example, press the
key until Port Type/IEEE 1284 displays. Press the - key until Centronics
displays.)
3. Press the ↵ key to select each new value. An asterisk (*) displays.
4. Before saving the modified configuration, you must delete the original
configuration if the Protect Configs. option is enabled.
a. Press the ↑ or ↓ key until the following message displays:
b. Press the
92
. .
key until the following message displays:
.
MENU MODE
CONFIG. CONTROL
Load Config.
Factory
or − key to cycle through the options: Factory 1-8.
+
following message displays:
Loading Saved
Configuration
Then, the following message displays when it is loaded:
Load Config.
X *
. .
key until PARALLEL PORT displays. Press the ↓
.
Delete Config.
1*
or − key to cycle through the options (1-8). When the
+
desired number displays, press the ↵ key to select it. The following
message displays:
Deleting
Configuration
Advertisement
Table of Contents
