Table of Contents
Advertisement
Chapter
3
CONFIG. CONTROL
Name Config (1-8)
You may specify a 15-character name which can be used to refer to a
configuration. The name you enter for a configuration will be used in the Load
Config., Save Config., Print Config., Delete Config., and Power-Up Config.
menus. The names can only be cleared by using the Reset Cfg Names menu.
When you move into the Name Configs. menu, the top line of the display
shows the current configuration name. The second line of the display is
initially the same as the top line. You can modify the second line of the display
without affecting the top line until the ↵ key is pressed, which sets the
modified name as the current selection.
Press ↑ or ↓ to cycle through the values available for that character at the
cursor location. Press + to move to the next character to be modified. Press −
to go back to a character you have already modified. Continue until you have
entered the name you want to give to this configuration, then press ↵ to save.
The name you entered will now represent this configuration on the printer's
front panel. To exit this menu without saving, press any key other than ↵. The
configuration name will revert to the last saved value.
The factory default is 1.
Reset Cfg Names
You can reset specific configuration names back to the default value of the
configuration number.
The options are 1-8 and All, and the factory default is 1.
124
Advertisement
Table of Contents
