IBM Infoprint 6700 Series User Manual page 323

Displayed Message
06 HOST REQUEST
08 HOLD PRINT
TIMEOUT
15 COMM CHECK
22 INVALID ADDR
27 CU TIMED OUT
28 CU NOT ENAB
33 HEAD OPEN
TIMEOUT
40V POWER FAIL
203 DPI Head
Installed
Table 17. LCD Message Troubleshooting
Can User
Explanation
Correct?
Yes Status message: in CT
emulation, the host computer
or printer controller requires
attention.
Yes Status message: in CT
emulation, the printer was
offline more than 10 minutes
and the "Intervention
Required" parameter is set to
"Send to Host."
Yes/No Communication Check: a
message that appears in the
CT emulation meaning the
line is not active on a twinax
interface.
Yes Invalid Address: poll time-out
on the twinax interface
indicating the unit address is
not recognized by printer.
Yes Controller Unit Timed Out:
the printer was not enabled
for one minute or more on a
coax interface.
Yes Controller Unit Not Enabled.
Poll time-out-error. The
printer was not polled for one
minute across a coax
interface.
Yes Status message in the CT
emulation: The printer was
offline more than 10 minutes,
and the "Intervention
Required" parameter is set to
"Send to Host."
Yes +40 VDC: an internal power
failure.
Yes Normal power-up message.
The printer is running its
initialization routine and
indicating DPI resolution of
the installed printhead.
Fault Messages
Solution
Not a printer problem.
Press PAUSE to put the printer online.
1. Check your network for proper
operation.
2. Try a different cable from a known
good device.
3. If the problem persists, contact your
authorized customer service
representative.
Have the system administrator make
sure the printer address is correct.
Check the cable connection and host
system. (Refer to the line problem
determination procedures, as
recommended by the host system.)
Check the cable connection and host
system. (Refer to the line problem
determination procedures, as
recommended by the host system.)
Close and latch the printhead. Press
PAUSE to put the printer online.
Power off the printer for 15 seconds,
then power back on. If the problem
persists, contact your authorized
customer service representative.
No action required.
323