IBM Infoprint 6700 Series User Manual page 326

Chapter 5
Restore The Printer To Operation
Table 17. LCD Message Troubleshooting (continued)
Displayed Message
DEACTIVATING
HOST SERIAL
DIAGNOSTICS
PASSED
DIRECT THERMAL
Remove Ribbon
DO NOT POWER OFF
DOWNLOADING TO
VALIDATOR
E-NET INIT
E-NET READY
E-NET RESET
EC SOFTWARE FAIL
See Manual
ENTER to Stop
ERROR: DC PROGRAM
NOT VALID
326
Can User
Explanation
Correct?
Yes Normal message that
displays when you set
Validator Funct. = Enable in
the VALIDATOR menu or
Battery Monitor = Enable in
the BATTERY CONTROL
menu.
Yes The printer passed its
memory and hardware
initialization tests.
Yes This is the normal reminder
message when you change
the Print Mode setting from
Transfer to Direct in the
QUICK SETUP or MEDIA
CONTROL menu.
No This is a standard warning
message that displays while
the printer is downloading
software.
Yes Normal message when the
printer is downloading
emulation software with a
validator option installed.
NOTE: Many software builds
contain updates to the
Validator option.
Yes Ethernet is initializing.
Yes Ethernet has finished
initializing.
Yes Ethernet interface is being
reset.
Yes/No Engine control software
failure.
Yes Normal message when a test
print pattern that will run
continuously has been
enabled.
Yes/No The printer cannot find the
data controller program or
the validation checksum is
corrupt.
Solution
No action required.
No action required.
1. Remove ribbon from the ribbon
supply and ribbon take-up spindles
in the printer.
2. If ribbon is required for printing,
change the Print Mode back to
Transfer.
Do not power off the printer until
downloading is complete.
No action required.
NOTE: The validator software update
can be verified in the F/W Revision
menu option of the VALIDATOR menu.
Shown as: Example X326
No action required.
No action required.
No action required.
Power off the printer for 15 seconds,
then power back on. If the problem
persists, contact your authorized
customer service representative.
Press the ENTER key to stop printing
the test pattern.
Power off the printer for 15 seconds,
then power back on. If the problem
persists, contact your authorized
customer service representative.