Table of Contents
Advertisement
Ticket Save Mode
This option determines the action of the media for Continuous (std), Tear-Off,
Tear-Off Strip and Cut Media Handling Modes after the printer is first powered
up or after the printhead has been opened and then closed. When enabled,
this option eliminates wasting label(s) or ticket stock when the printer
advances media to search for the next TOF position.
•
Enable. The printer will assume that media is at the TOF position after
cycling power or after the printhead is opened and then closed. When a
print job is sent it is printed without advancing media to search for the next
TOF position.
NOTE: The user must ensure that media is at the correct TOF position (cross
perforation, liner gap, notch or mark at the tear bar edge) before
cycling power or before closing and locking the pivoting deck. In
addition, media must be calibrated and the correct Media Handling
Mode, Label Length and Gap/Mark Sensor selected and saved as the
Power-Up Config. Option applies to 2.5 inch or longer label lengths
only.
•
Disable. The printer assumes that the media is not at the correct TOF
position after cycling power or after the printhead is opened and then
closed and advances media until the next gap, notch or mark is detected
by the Media Sensor(s). When print data is sent, printing begins only
after the next TOF is detected, resulting in one or more blank labels being
advanced.
The factory default is Disable.
TOF Adjust Mode
•
Enable. This option enables the "TOF Adjust" distance set using the TOF
Adjust menu (see below).
•
Disable. his option disables the "TOF Adjust" distance set using the TOF
Adjust menu (see below).
The factory default is Disable.
TOF Adjust
This opton sets the distance from the Top Of Form (TOF) that is left blank
(unprinted) after a label has been removed in Tear-Off mode. Normally
printing is done starting at TOF, but when this mode is enabled the start
position for printing can be adjusted from 0.00 to 0.40 inches from TOF (in
increments of 0.01 inch). This adjustment can be helpful if media stick to the
platen by means of jagged edges created during media removal using the
tear bar. By controlling how much blank space there is from TOF, you can
control how much the media is called back after it is torn off.
MEDIA CONTROL Submenus
143
Advertisement
Table of Contents
