Table of Contents
Advertisement
Chapter
3
Emulation Submenus
Character Set (P-Series, Serial Matrix, Proprinter, Epson FX)
(From page 190, page 195, page 197, page 199.) This item allows selection
of the character set to be used by the printer.
Cmd Resolution
(From page 188.)
•
Low Resolution. Sets a low command resolution mode.
•
High Resolution. Sets a high command resolution mode.
The factory default is Low Resolution.
Coax Type
(From page 167.) This parameter defines the printer emulation, as follows:
•
4234
•
3287
After the emulation has been changed, a POR status is sent to the host.
The factory default is 4234.
Code Page Subset
(From page 175.) This item allows you to select the desired version of the
following code pages - 037,273, 274, 275, 277, 278, 280, 281, 282, 284, 285,
297, 500, and 871.
The options are Version 0 (the factory default) and Version 1.
Compressed Print
(From page 194.) Controls which host command sets compressed printing.
•
Char 01 SOH
•
Char 03 ETX
•
Char 09 HT
The factory default is Char 01 SOH.
Control Code 06
(From page 191, page 194, page 196.) Control Code 06 defines the function
of ASCII code 06 hex (ACK). You can select an alternate line spacing of 6.0,
8.0, or 10.3 LPI.
The options factory default is 8.0 LPI.
Control Code 08
(From page 191.) Control Code 08 defines the function of ASCII code 08 hex
(BS). You can define the code to output an Elongated character or a
Backspace. The factory default is Elongated.
212
Advertisement
Table of Contents
