IBM Infoprint 6700 Series User Manual page 236

Chapter 3
Emulation Submenus
Repeat Form Opt
(From page 185.)
•
Enable (the default). Speeds up the processing of repeated forms for
PGL, thereby resulting in increased printer throughput. This option
provides no speed benefit for forms that are unrelated to one another and
should be disabled under those circumstances.
•
Disable. Should be selected when subsequent forms are unrelated to
one another.
Reset Cmd CFG Ld
(From page 192, page 194, page 196, page 198, page 200.)
When the printer receives a host data stream reset command (ESC@ or
ESC[K) in addition to resetting printer variables, the selected configuration is
loaded.
•
Disable (the default). The active emulation parameters are loaded when
the reset command is executed.
•
Power up config. The power-up configuration is loaded when the reset
command is executed.
•
Current config. The currently selected configuration is loaded when the
reset command is executed.
•
Factory config. The factory installed configuration is loaded when the
reset command is executed.
Resident Font
(From page 175)
This option selects either a bit-mapped font ("Compatible") or a scalable font
("Scalable") as the default font.
•
Compatible (the default). Selects a bit-mapped font as default.
•
Scalable. Selects a scalable font as default.
Ret. Status Port
(From page 184.)
This option selects the port for the Return Status Commands (i.e., ~STATUS
(PGL) and ~HS (PPI/ZGL)) to send the status data back to the Host. The
default is Serial. The remaining options include E-NET Stat Port, E-NET Data
Port for Ethernet connection, and Disable.
Right Margin
(From page 190, page 193, page 195, page 197, page 199.)
Set in characters. Character zero is defined as the far right edge of the page,
and column numbering increments from right to left.
The range is 0-369 characters, and the factory default is 0 characters.
236