IBM Infoprint 6700 Series User Manual page 232

Chapter 3
Emulation Submenus
PA1
(From page 167, page 173.) PA1 is only valid when the printer is in the offline
state and the coax Systems Network Architecture Character Set (SCS) data
stream is active. This function displays the "PA1 ENABLED" message when
the ENTER key is pressed, and sends a special operator request to the host
when the printer is put back online. Refer to the Coax/Twinax Programmer's
Reference Manual for more information about SCS.
NOTE: Selecting PA1 again ("PA1 DISABLED" appears on the operator
PA2
(From page 167, page 173.) PA2 is only valid when the printer is offline and
the coax SCS data stream is active. This function displays the "PA2
ENABLED" message when the ↵ key is pressed, and sends a special
operator request to the host when the printer is put back online.
NOTE: Selecting PA2 again ("PA2 DISABLED" appears on the operator
Page Rotation
(From page 175.) This option rotates the physical IPDS page.
The options are 0, 90, 180, and 270.
The factory default is 0.
PGL Normal
(From page 185.) This option determines whether PGL passes the text data in
Normal mode according to LP+ or whether PGL will print the text data itself.
•
LP+ Menu (the default). PGL will pass the text data to LP+ only in the
default setting state (6 LPI, default character set, and font attribute).
•
PGL Menu. PGL will always print the text data itself.
PI Slew Range
(From page 184.) You can specify how many lines the paper will feed.
•
15. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will move
1 line.
•
16 (the default). A paper slew of 0-15 will move 1-16 lines.
232
panel) or selecting PA2 will reset the pending PA1 function.
panel) or selecting PA1 will reset the pending PA2 function.